This Circuit helps in the monitoring of mains supply voltage. It does not use a isolation step down transformer. This has to be constructed only by skilled people with knowledge of safety requirements.
C1 limits the current and drops most of the voltage. The zener regulated supply is for the chip. C2 can be raised to 220uF or more if required. The bar mode display may consume more power.
Mains Voltage Power Transformers
R2-R3-R5-R6 form a voltage divider to get a sample of the input voltage, D11-C3 get the DC value.
Adjust R5 preset with a log Plastic tweaker to get the 5th led to just turn on when input voltage is at 138V AC. This has to be done after PCB is put in a sealed fire-retardant-plastic or epoxy box. drill a hole in box for plastic tweaker.
National LM3914 - Dot Bar Display Driver
This Circuit is Not a Tested Design. It is an Idea for study
Warning : This Circuit is Mains Operated without Isolation Transformer and will give lethal electric shock if touched when the circuit is turned on. Test circuit only with DC 9V Bench Power Supply to try it out. Do not use 230V AC.
Feedback awaiting moderation
This post has 1 feedback awaiting moderation...